|
Prepare before driving: (1) put on clothes, wear a helmet, gloves, masks and other protective equipment; (2) Check for loose screws ministries, whether there is an obstacle around the motor device, whether the ore crushing cavity or debris, the degree of correction belt tension, all the screws to be tightened spring; (3) Check the port of discharge gap desirable. cone crusher machine discharge mouth gap kept 30-45㎜, cone crusher machine discharge mouth gap kept 13-15㎜; (4) Check the power supply is normal, all the electrical protection system is intact. The operation: (1) After starting the first time oil is heated to 25-30 degrees pump motor for 5-10 minutes, checking the work of the lubrication system, oil pressure in 0.11-0.18Mp, observe the oil return pipe back to normal, oily meet the requirements before start the main motor; (2) Check lubrication station per hour for the return line temperature does not exceed 50 degrees, enough to tank volume, the normal height of the oil in the tank. Lubricating oil pump cone subject lines or no leakage; (3) crusher machines empty load operation for 1-2 minutes to open the belt and began to mine the ore can be crowded, pay attention to the mine is normal, especially mud and more high moisture ore, to prevent clogging of ore to mine mouth. Parking: (1) normal stop, stop to the mining, ore crusher machine After all ruled out, in order to stop the main motor is running, and finally stop the pump motor; (2) Carefully check after stopping in various parts of the crusher machine , identify problems in time. Notes: (1) pay attention to prevent excessive oil pressure, oil pressure over 2 kg / cm2, will spill hurt; (2) the operation of inspection, should ensure good coupling guard to prevent the coupling screw shake off flying wounding; to prevent excessive pressure, the succession of the stretched open, the oil spill hurt. |
